Timing Belt/Chain and Cover and Balance Shaft for 2016 Chrysler 300
NOT Included With Long Block Engine Install Kit. Coolant Crossover.
M6x1.00x25.00. Reinf plate to rambox inr. Crossover ot front cover. Crossover Attaching. Oil Pump. Crossover to timing cover. Crossover to frot cover. Crossover to front cover. Crossover to front pump. Pump To Front Cover.
Push On Nut, Mounting
M6. Coolant Crossover. Sleeve/Bushing Oil Filter Adapter. Mounting, Timing Chain Cover. Intake Manifold To Cylinder Head. Insert Cylinder Head Cover. Cylinder Head Cover To Cylinder Head.
M6x1.00x48.00. Crossover To Block. Crossover attaching. Water pump attaching. Timing cover, water pump, and crossover to engine. Coolant Crossover To Front Cover. Crossover to head.
Output Shaft to Engine. Timing Case Cover To Cylinder Head. M8x1.25x45.00. Front Cover to Head. Timing Case Cover To Cylinder Block.
Torx Head Bolt, Mounting
Left Bank Timing Drive Guide. Primary Tensioner. M6x1.00x30.00. Primary Drive Guide. Left Side Timing Cain Guide. Right Side. Left Side Timing Chain Guide. Timing Chain Gude.
Right Side. If A Short Block Engine Has Been Installed,The Timing Chain Guide Pins Are NOT Installed In The New Cylinder Block.Pin Kit 68146903AB Must Be Installed Before Timing System Can Be Installed. Secondary Right.
If A Short Block Engine Has Been Installed,The Timing Chain Guide Pins Are NOT Installed In The New Cylinder Block.Pin Kit 68146903AB Must Be Installed Before Timing System Can Be Installed. Secondary Left.
If A Short Block Engine Has Been Installed,The Timing Chain Guide Pins Are NOT Installed In The New Cylinder Block.Pin Kit 68146903AB Must Be Installed Before Timing System Can Be Installed.
Torx Head Bolt, Mounting, Right Side
M6x1.00x15.00. Secondary Right Side Timing Chain Guide.
Oil Pump Drive Gear. [M8x16]. Sprinter. M8x1.25x16.00.
M8x1.25x16.00. Oil Pump To Drive Gear. [M8x16]. Oil Pump Sprocket. Sprinter. Intake Support Bracket To Cylinder Head.
Hex Flange Head Screw, Mounting
M5x0.8x12.0. Oil Pump Splash Shield To Oil Pump. Mounting DPS Heat Shield to DPF. Mounting DPF Routing Bracket and SCR Sensor. Tube attaching. Fuel Filter to Bracket. IP Carrier To Display Diecast. Pressure Tube Attachment. DPF Bracket to DPF.